Bei-sensors MHK5 Absolute Hollow Shaft Encoder Manuel d'utilisateur télécharger pdf (Page 29)

Revision 03/10 BEI Sensors Profibus Manual serie M Page 29

6.2.11 Zero offset

The zero offset is output in diagnostic bytes 32 to

35.

6.2.12 Programmed resolution

he programmed resolution per revolution is output

in diagnostic bytes 40 to 43. The value is only valid

if the scaling factor is based on the parameter

„resolution per revolution“ (cp. 5.1.3).

6.2.13

Programmed total resolution

The programmed, respectively calculated total

resolution is output in diagnostic bytes 44-47.

6.2.14 Serial number

Diag

nostic bytes 48-57 are intended for a serial

number.

With the current version the serial number is not

saved in the encoder, the bytes contain the default

value 2A hex.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 47 48

Pas de commentaire

Bei-sensors MHK5 Absolute Hollow Shaft Encoder Manuel d'utilisateur Page 29